Jump to content

Valve clearence question....opinions needed


Recommended Posts

Hey guys I'm in the middle of checking my valve clearances on my '01 Sp1 and most of them are within spec.All except one of the intake valves on the front cylinder.It measures 0.004in

The workshop manual states :

IN:0.16mm plus/minus 0.03mm(0.006in plus/minus 0.001in)

My question is this, Could i get away with leaving this one valve it as is, seeing as it's on 0.001in out?

Any help or advice would be greatly appreciated!! :D



Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...