addiction269 Posted March 17, 2010 Report Share Posted March 17, 2010 Looking to bore out an r6 motor - any ideas on cost and where would be best to go? cheers Link to comment Share on other sites More sharing options...
Gregorious77 Posted March 18, 2010 Report Share Posted March 18, 2010 I have used PJ engineering for 2 stroke before and they are very good. Give them a call I am sure they can help you out. Link to comment Share on other sites More sharing options...
Evilchicken0 Posted March 18, 2010 Report Share Posted March 18, 2010 I paid £150 for my barrels to be bored .... I think it was 1.5mm but not sure. The barrels didn't need plating after - R6's might Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.