drunkn munky Posted August 25, 2012 Report Share Posted August 25, 2012 I have a rear axle that for starters needs the thread sorting on either the axle itself or the large axle nut, and also another large nut machined to suit a different wheel setup. This is the axle in question The large wheel nut/spacer combo on the left only goes so far onto the axle then locks dead, to me it looks as if the thread in the nut could be damaged as the axle looks fine. Id also like another wheel nut machined to suit a flat spacer rather than the conical one thats in the pic so i can also fit wheels with a flat face. I already have the spacer. Anyone fancy taking this on? Obviously i'll pay, I dont mind sending it out but would prefer someone local to kent if possible. Link to comment Share on other sites More sharing options...
speedy sie Posted August 25, 2012 Report Share Posted August 25, 2012 http://www.ti64.co.uk/ try this chap he is a star and his work is some of the best iv seen in a long time. ..spoke to him about him doing some work for me and he is a true tec head and he does know his stuff,most that have had work done by him are very impressed at the quality of the work,will make one off as well Link to comment Share on other sites More sharing options...
Romski Posted August 25, 2012 Report Share Posted August 25, 2012 Porter Jamie is your man, have a look on the trade board. Local to you as well. Link to comment Share on other sites More sharing options...
drunkn munky Posted August 25, 2012 Author Report Share Posted August 25, 2012 Porter Jamie is your man, have a look on the trade board. Local to you as well. Thanks going to get it sorted tuesday! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.